Scaleart Fahrgestell Bohrungsabstände

  • Hallo,
    ich bin zur Zeit dabei mein eigenes Modell zu planen. Um später evtl. Teile von Scaleart hinzuzufügen bräuchte ich eure Hilfe bei folgenden Abmessungen vom Fahrgestell.

    Bohrungen für die Anhängerkupplung an der Heck Traverse:

    Grundplatte der Sattelplatte:

    Euro Kotflügel:


    Wäre euch sehr Dankbar, falls sich wer die Mühe macht und genau nachmisst.

    Gruß Lennard

  • Hope these are the measurements you need. Measured as close from center to center as I could.

    Some of the holes are shaped oval.

    I do not use the Euro fenders. So I measured the distance center to center of the holes the supports go in.

    Maybe someone can double check just to make sure.

    Stephan

  • You again :D
    This is just tremendous. Thank you, this is highly appreciated. You did this very detailed! Also thanks for the hint with the oval shaped holes!

  • Yes ... seems like you are asking for these details just when I have those parts lying around.
    Least I can do is help you out. Once the truck is finished it is very hard to take measurements.

    Forgot to let you know the diameter of the fender support. It is 3mm.

    Will be interesting to see what you are going to build!