1:8 CAT 349FL

Hello everyone,

I have been working on a 1: 8 scale CAT 349FL excavator for almost 6 months now, here are some pictures of my progress so far. You can check out my facebook page for more pictures and videos here: https: //http://www.facebook .com / profile.php? id = 100033637335479

Zitat von Boris_25

Salut [user = '32482'] Cleo1279 [/ user],

Joli travail, et heureux de voir une belle réalisation venue de France. What about the patins de chenille?

Hi [user = '32482'] Cleo1279 [/ user]

Nice job, happy to see a model from France. Do tracks are casting models?

Oui, les chenille sont Coules en acier inoxydable.

It has been a long time since I have updated this post. I have finally found some time to keep working on my excavator. I finished drawing the hose clamps and the bucket teeth. I printed them on my 3D printer to see how they would look. I am quite happy with results. I will now continue by casting them in stainless steel. I redesigned my boom as I was not satisfied with the previous one, it did not have enough detail. Let me know what you guys think so far Any comments or advice will be greatly appreciated.

Best regards

Cleo

These past few weeks I have been working on the swing motor for my 1:8 scale CAT 349FL excavator. I am very happy with the results. I 3D printed the bottom piece as a test. The metal one should be done in a few days.